User Guide

41
4.3
Setting According to Report Method
♦ To set the base setting
Use the [Report] property sheet of the [Base Setting] dialog to select the method from the list and make
the setting in the dialog displayed by pressing the [Configure...]. To report Alert, make settings by
clicking the function status bitmap and change to green.
♦ To set destination setting
Select the method from the method list at the time of ID setting in the [Destination Setting] dialog and
make the setting in the dialog displayed by pressing the [Address...].
Manager Report (SNMP)
4.3.1
No item is provided to set in AlertManager for the base setting and destination setting. Make the setting of
SNMP service in Control panel [Network] of Windows. Set also a destination of the remote manager using
SNMP service.
Manager Report (TCP/IP In-Band)
4.3.2
No base setting is required. Make the following setting for destination setting.
♦ [Manager (TCP/IP In-Band)] dialog
- [IP address (or host name)]:
An IP address (or host name) of the remote Manager is set.
Make sure to specify IP address of the remote Manager.