User's Guide

1. Installing Internal Optional Devices

Express5800/R120e-1M User’s Guide

Chapter 2 Preparations

1.3

Overview of Installation and Removal

Install/remove components by using the following procedure.

Installing/removing internal components except for hard disk drives should be done after dismounting the

server from the rack. It is recommended that more than one person removes the server from the rack.

CAUTION

Be sure to observe the following precautions to use the server safely. Failure to

observe the precautions may cause burns, injury, and property damage. For

details, refer to Safety precautions in Precautions for Use.

• Do not drop the server

• Do not leave the server pulled out of the rack

• Replace the cover after installing components

• Beware of high temperatures

• Do not get your fingers caught when installing components

1. If the server is mounted on a rack, use the UID switch to identify the target server.

See Chapter 2 (1.4 Confirming Servers (UID Switch)).

2. Remove Front Bezel.

See Chapter 2 (1.5 Removing Front Bezel).

3. If the server is ON, turn it off.

See Chapter 3 (6. Turning Off the Server).

4. Disconnect the power cord from the outlet and the server.

Important

After disconnecting the power cord from the server, wait for at least 30

seconds before continuing to work because the components on the

motherboard might still be operating for about 30 seconds even after the

power cord was disconnected.

5. You need to pull out the server from rack and put it on a flat rigid desk when installing or removing the

components other than the following two devices:

See Chapter 2 (2.1 Installation) for details.

Hard disk drive Power supply unit

Important

Do not leave the server open on the rack.

If you are going to install a hard disk drive only, go to step 10.

6. Remove Top Cover.

See Chapter 2 (1.6 Removing Top Cover).

7. Depending on the components to be installed or removed, follow the procedure in order.

See Chapter 2 (1.7 Internal Flash Memory) to (1.16 Use of Internal Hard Disk Drives in the RAID

System).