Maintenance Manual

1. POST Error Message
Express5800/R120d-1M, R120d-2M Maintenance Guide
109
Chapter 3 Appendix
(2) Error reporting via beep
Even if an error is detected by POST, the error message may be unable to be displayed in the display. In this
case, the server beeps to report that an error has occurred.
For example, the beep code 1-3-3-1 indicates 1 beep, a pause, 3 beeps, a pause, 3 beeps, a pause, and 1 beep,
which means that an error occurred while checking the memory capacity.
The table below shows the beep code, cause, and solution.
Beep Code Cause Solution
1-3-3-1 No memory module is not installed.
Or, no memory is detected.
Make sure that the DIMMs are correctly inserted.
If the same error is detected repeatedly, ask your sales
representative to replace DIMM or motherboard.
1-5-2-1 The processor is not installed.
Or, no processor is detected.
Make sure that the processor is correctly mounted. If the
same error is detected repeatedly, ask your sales
representative to replace DIMM or motherboard.
1-1 No graphics controller could be detected. Contact your sales representative.
1 POST detected an error.
3 Failed to read BIOS data.
Or, failed to execute BIOS.
4 Failed to initialize the BIOS executable
module.
7 Failed to reset the system.
8 An error was detected when allocating the
PCI resources.
Remove all the installed PCI boards to PCI slots, and
then reboot the server.
If the same error is detected repeatedly, contact your
sales representative.