Installation Guide

39
SSCOPE Engine 3
O Manager.
For details of [BMC Setting], see the online help of NEC ESMPRO Manager.
tween NEC ESMPRO Manager's
It may take a few minutes to set the Standby BMC Configuration.
aiting for a few minutes.
ing] of NEC ESMPRO Manager, Advanced
the destinations.
nabling DHCP
Set DHCP setting for Advanced Remote Management Card using BMC configuration tools on the managed
in. If you re-install, you
elete the files by “delete” command before re-installing.
♦ The default setting of EXPRES
You can change BMC Configuration Information from [BMC Setting] of NEC ESMPR
Refer to EXPRESSSCOPE Engine 3 User’s Guide about difference be
default value and a value which 'Configuration Initialization' function will set.
♦ Standby BMC Configuration Setting
If the setting is faile
d, please set it again after w
♦ DHCP setting for Advanced Remote Management Card
If you change DHCP setting to [Enable] on [BMC sett
Remote Management Card may not be able to send the alert to
The reason is that MAC address for the destination becomes unsuitable in the case that e
changes the address range.
server.
♦ In case of interruption to install NEC ESMPRO Manager
In case of interruption to install NEC ESMPRO Manager, unnecessary files may rema
must d