Setup Guide

NEC ESMPRO Manager Setup Guide
93
6.3.2 Register the Managed Component
Use either of following two methods to register the managed component.
 Manual Registration
This method requires the operator to directly enter the managed component's information such as the IP
address of the vPro and to perform "Check Connection".
 Auto Registration
This method automatically searches the network for managed components that are not registered yet on
the NEC ESMPRO Manager and registers them.
(1) Manual Registration
(1)-(a) Click the group name to which the managed component based on vPro will belong on the
"Component List" or the "Group" tree.
(1)-(b) Click the "Manual Registration" from "Add Component" of "Group Information" tab.
(1)-(c) Input the following items.
--"Component Name"
Specify the name of the managed component on NEC ESMPRO Manager.
Assign a name different from other managed component names. Do not enter a name including blank
characters. Uppercase characters are distinguished from lowercase characters.
--"Common Setting"
-"OS IP Address"
Specify the OS IP Address of the managed component.
--"System management"
-"Management"
Select "Registration" to manage the component using "System management".
--"RAID system management"
-"Management"
Select "Registration" to manage the RAID system of the component.
--"NEC ExpressUpdate"
-"Updates via NEC ExpressUpdate Agent"
Select "Registration" to manage the component using NEC ExpressUpdate.
--"Management controller management (Common)"
-"Management"
Select "Registration".
-"Management Type"
Select "vPro".
-"User Name"
Enter the user name for communication with the vPro.
-"Password"
Enter the password for communication with the vPro.
--"Management controller management (LAN)"
-"IP Address 1"
Enter the IP address that is specified on LAN of the iAMT configuration for the managed
component.
CHECK:
 This IP Address and OS IP Address are the same if you set the DHCP mode to
"ENABLED" on the iAMT configuration.