Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide

4.3 Setup for EM Card

4.3.1 Setup Flow

Perform the following setup procedure:

(1) Connect the NEC ESMPRO Manager server and the EM card.

(2) Setup EM card for communication with NEC ESMPRO Manager.

(3) Register the EM card on NEC ESMPRO Manager.

4.3.2 Setup EM Card for communication with NEC ESMPRO Manager Setup

the EM Card as follows. See Users Guide that attached to EM Card for detail.

(1) Set the IP address of the EM Card.

CHECK:

 The IP address set on the EM card should be the value that can be divided by 4. If the IP

address be set other value, NEC ESMPRO Manager will fail "Check Connection".

 NEC ESMPRO Manager communicates to the EM card with the "fixed IP address".

(2) Setup EM Card for communication with NEC ESMPRO Manager.

Use setdsl command for SIGMABLADE-M.

Use SET DSGPASSWORD and SET DSGSTATE command for SIGMABLADE-H.

4.3.3 Register EM Card on NEC ESMPRO Manager

You can register the EM card with similar way of registering the ordinary managed component.

Use either of the two methods to register EM card.

 Manual Registration

This method requires the operator to directly enter the EM card's information such as the IP address and

to perform "Check Connection".

 Auto Registration

This method automatically searches the network for managed components and EM card that are not

registered yet on the NEC ESMPRO Manager, and registers them.

TIPS:

 NEC ESMPRO Manager distinguishes the EM card from ordinary managed component by

"Check Connection".

 After "Check Connection" of the EM card is completed, Information of the blade enclosure

(chassis) is displayed on the "Chassis List" on the NEC ESMPRO Manager.

 The chassis name on the NEC ESMPRO Manager is set to the first 16 characters of the

blade enclosure name. If the same name is already registered, some number is added to the

name.

You can change the chassis name on "Chassis Information".