Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide

CHECK:

 To communicate with the NEC ESMPRO Manager via LAN2, make the setting on the

"LAN2" tab as same as "LAN" tab. If the BMC of the managed component does not

support communication via LAN2, the values of "LAN2" tab page have no effect with the

managed component.

 The managed component installed the BMC that uses Management LAN port supports the

function of "Obtain an IP Address automatically (DHCP)".

(5) Insert a formatted floppy disk into the FD drive, and click "OK". A dialog box will appear for specifying

a location where the configuration information is to be saved.

(6) Specify the floppy disk's root directory as the location.

Enter "CSL_LESS.CFG" for the file name, and click "OK".

The configuration information file will be saved on the floppy disk. This floppy disk is called a

"configuration information FD".

CHECK:

 Place the configuration information FD in the write-enable state.