Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide
46
2.2.2.2 Setting the IP address assigned by the DHCP
Perform the following procedure.
(1) See 2.2.3.1"Create a configuration information file" to create a con
figuration information file.
IMPORTANT:
 To use the configuration information file for NEC ESMPRO Manager PXE Service, there
are some different from the description of 2.2.3.1 "Create a configuration information file".
These item
s will not be set to the managed component.
-- If EXPRESSSCOPE ENGINE series is integrated in the managed component:
- "Common" tab page
"Computer Name"
- "LAN1" tab page
"Obtain an IP Address automatically (DHCP)"
"IP Address"
"Subnet Mask"
"Default Gateway"
-- If Advanced Remote Management Card is integrated in the managed component:
- "Common" tab page
"Computer Name"
- "LAN1" tab page
"Obtain an IP Address automatically (DHCP)"
"IP Address"
"Subnet Mask"
-- If the other BMC is integrated in the managed component:
- "Common" tab page
"Computer Name"
- "LAN1" tab page
"Obtain an IP Address automatically (DHCP)"
"IP Address"
- "LAN2" tab page
All items
 The configuration file name and path name are not required specified names.
(2) To start NEC ESMPRO Manager PXE Service, click "Linkage Service" from the "Header menu" on the
NEC ESMPRO Manager.
Click "Start" on the "PXE Service" screen.
The NEC ESMPRO Manager PXE Service will start and be ready to accept network-boot requests.