Setup Guide

NEC ESMPRO Manager Ver.5 Setup Guide

2.2.2 Configuration with NEC ESMPRO Manager PXE Service (for LAN

connection)

Set configuration information for the BMC on the managed component by using the NEC ESMPRO

Manager PXE Service.

The NEC ESMPRO Manager PXE Service accepts network- boot requests only from the component to be

managed by the DHCP server.

CHECK:

 NEC ESMPRO Manager PXE Service can be installed only on Windows.

There are two methods.

 Setting the IP address assigned by the DHCP.

 Setting the IP address specified in the computer information list.

2.2.2.1 Notes of Configuration with NEC ESMPRO Manager PXE Service

This section explains particular notes of Configuration with NEC ESMPRO Manager PXE Service.

-- When you set the IP address assigned by the DHCP, NEC ESMPRO Manager PXE Service configures the

BMC to obtain the IP address by the DHCP if the BMC that uses Management LAN Port is integrated in

the managed component.

Since the NEC ESMPRO Manager PXE Service does not configure the IP address, the IP address is not

shown in Computer Information list of the NEC ESMPRO Manager PXE Service.

-- If Advanced Remote Management Card is integrated in the managed somponent, the BMC may not

immediately obtain the IP address after NEC ESMPRO Manager PXE Service configures the BMC to

obtain the IP address by the DHCP. Please turn the managed component AC-OFF and AC-ON because the

BMC try to obtain the IP address whenever the managed component is turned AC-ON.

-- If the DHCP server does not respond within the fixed period of time, the BMC will stop trying to obtain

the IP address. Then NEC ESMPRO Manager cannot search the managed component with the function

"Auto Registration". In this case, please turn the managed component AC-OFF and AC-ON. See

2.2.2.5"Procedure to retry configuration

with NEC ESMPRO Manager PXE Service" for retry.

-- If the BMC that uses standard port is integrated in the managed component, the managed component needs

to be made network-boot via LAN1. Set the priority to LAN1 to become higher than LAN2 with BIOS

Setup Utility.

-- While the NEC ESMPRO Manager PXE Service is active, do not network-boot a managed component that

has been configured by a method other than using the NEC ESMPRO Manager PXE Service. Otherwise,

the configuration is performed with the NEC ESMPRO Manager PXE Service, resulting in the change of

the original configuration information. In this case, the component may not be managed through the NEC

ESMPRO Manager.

-- Before starting the NEC ESMPRO Manager PXE Service, stop other PXE services and software having

the PXE service function in the network. If you use other PXE services and software having the PXE

service function, stop the NEC ESMPRO Manager PXE service and then start them.

This procedure is necessary to start the service that you want to use.

Click "Run" from "start" of Windows. Enter the command as following example. It shows case that the

installed directory of NEC DeploymentManager is "C:¥Program Files¥NEC¥DeploymentManager".

Stop: "C:¥Program Files¥NEC¥DeploymentManager¥svcctrl" –stop

Start: "C:¥Program Files¥NEC¥DeploymentManager¥svcctrl" –start