User's Guide

1. Installing Internal Optional Devices

Express5800/R120d-1E User’s Guide

Chapter 2 Preparations

8. Connect the riser card C to the mother

board slot. Fix the riser card with three

screws you have removed in Step 3.

When connecting the card, position the

terminal part of the card to the slot on the

motherboard and insert it.

9. Connect the riser card B to the mother

board slot. Fix the riser card with three

screws you have removed in Step 2.

When connecting the card, position the

terminal part of the card to the slot on the

motherboard and insert it.

10. Continue to install or remove internal optional devices, mount and connect the server, and turn it on.

11. Make sure that no error messages are displayed on POST screen.

For details on POST error messages, refer to Chapter 3 (1. POST Error Message) in "Maintenance

Guide".

12. Start the BIOS Configuration utility on the mounted board to set up the board.

Availability or startup and operation procedure of the utility depends on board. For details, refer to the

manual that comes with the board. If a PCI card including RAID Controller, SCSI controller, and LAN card

which connects to any bootable device is added, the boot priority might be changed to the default setting.

In that case, configure the boot priority in the Boot menu of the BIOS Setup utility. For details about the

Boot menu, refer to Chapter 2 (1.2.5 Boot) in "Maintenance Guide".

Screws