User's Guide

1. Installing Internal Optional Devices

Express5800/R120d-1E User’s Guide

Chapter 2 Preparations

4. Confirm the installation position with the reference to the table in (1.12.2 Supported cards and available

slots).

5. Remove the screw from the rise card and

remove the blank cover.

(This step is common for PCI #1B and #1C.)

Note

Keep the slot blank for future use.

6. Install riser card.

When installing the card, position the terminal part of the PCI card to the riser card slot and insert it.

Important

Do not touch the terminal part of riser cards or PCI cards and the signal pins

of electric parts installed on the card. Installing cards with dirt or oil can

cause malfunction.

Note

 Make sure that the head of a PCI card bracket is seated into the fixed slot.

 Depending on type of PCI cards, the terminal part of the PCI card may be too

large to fit in the connector.

 If you have trouble installing the card, remove the card once and try again. If you

apply excessive pressure on the card, a PCI card or riser card might break.

7. Fix the PCI card with the screw you removed in Step 5.

Tips

Connect a cable between connector on motherboard and PCI card before

installing the riser card to the server.

Screw

Riser card B Riser card C