User's Guide

1. Installing Internal Optional Devices

Express5800/R120d-1E User’s Guide

Chapter 2 Preparations

(1)

When using the optional RAID Controller (N8103-149/150/151)

For details, refer to the manual that comes with optional RAID Controller (N8103-149/150/151).

Important

 You must avoid static electricity to work with the procedure below. For

details, refer to Chapter 2 (1.2 Anti-static Measures).

 Do not change the mode to hibernate when building a RAID System.

Note

 When installing an optional RAID Controller, start the BIOS Setup utility, select

PCI Configuration from the Advanced menu, and then make sure that the

parameter of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.

 When connecting a RAID Controller, set the boot priority to 8th or higher in the

Boot menu of the BIOS Setup utility. If the setting is 9th or lower, the

configuration menu for RAID Controllers cannot be launched.

PCI #1B/#1C

1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.

2. Remove the three screws from the rise card

B. Hold the both ends of the riser card and

lift it off.

Note

Be careful not to contact with other components.

3. Remove the three screws securing the rise

card C. Hold the both ends of the riser card

and lift it off.

Note

Be careful not to contact with other components.

Screws