User's Guide

1. Installing Internal Optional Devices
Express5800/R120d-1E User’s Guide
72
Chapter 2 Preparations
1.12.3
Installation
Install a riser card to a PCI card in the following procedure.
Important
When installing a PCI card, make sure the connector of the card fits the
connector of the riser card.
Note
Check the card type (low profile or full-height type) which respective riser card
supports and the type of PCI card to be installed.
PCI #1A
1. Refer to Chapter 2 (1.3 Overview of Installation and Removal) for preparations.
2. Remove the screw securing the rise card.
Hold the both ends of the riser card and lift it
off.
Note
Be careful not to contact with other parts.
3. Confirm the installation position with the reference to the table on the previous pages.
Confirm the installation position with the reference to the table in (1.12.2 Supported cards and available
slots).
4. Remove the screw, and remove RAID
Controller bracket.
Screw
Screw