User's Guide

2. BIOS Setup Utility (SETUP)
Express5800/R120d-1E User’s Guide
125
Chapter 3 Setup
2.4
Cases that Require Configuration
Only if a case applies to any of following cases, use SETUP to change a parameter which was configured as
factory setting. Other than cases described below, do not change the settings. A list of SETUP parameters
and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance Guide".
Category Description Setting of parameter Remark
Change date and time Configure date and time
Main  System Date
Main  System Time
Configurable on OS
On NumLock on power ON
Boot  Bootup Numlock State 
On
Basic
Off the function to display
the NEC logo during POST
Boot  Quite Boot  Disabled
By pressing the <Esc> key,
prevent the display of the
logo.
Memory configure after add
or change DIMM
Advanced  Memory
Configuration  Memory Retest
 Yes
After rebooting, Memory
Retest changes No
automatically.
Memory
Use memory RAS feature Change to RAS mode
Advanced  Memory
Configuration  Memory RAS
Mode
You can select Mirroring,
Lock Step, or Sparing.
Optional
board
Disabled Option ROM that
installed RAID Controller
board
Advanced  PCI Configuration 
PCI Device Controller and Option
ROM Settings  PCI Slot n
Option ROM  Disabled
n is PCI slot number of the
RAID Controller
Change the boot order of
devices
Change the boot priority
Boot  Boot Option Priorities
When you use
EXPRESSBUILDER, set
CD/DVD to the highest
priority.
Use remote power on
function (from modem)
Advanced  Advanced Chipset
Configuration  Wake On Ring 
Enabled
Use remote power on
function (from RTC alarm)
Advanced  Advanced Chipset
Configuration  Wake On RTC
Alarm  Enabled
Boot
Control from HW console
terminal
Change respective setting
Advanced  Serial Port
Configuration . Console
Redirection Settings
Set a password to restrict
operation of SETUP Utility
Set a password
Security  Administrator
Password
Security  User Password
if you set password, you
havet to enter password
when starting SETUP
Utility..
Security
Set a password to restrict
Boot
Security  Password On Boot 
Enabled
You can select this
parameter after you set
password.
When the server is supplied
with power from UPS,
always turn on the power.
Server  Power Control
Configuration  AC-LINK  Power
On
If it is turned off by using
POWER switch, leave it
OFF even when UPS
supplies power.
Server  Power Control
Configuration  AC-LINK  Last
State
UPS
Powerlink
Keep the power OFF even
when UPS supplies power.
Server  Power Control
Configuration  AC-LINK  Stay
off