Manualshelf

User's Guide

ManualsBrandsNEC ManualsserversNEC Express5800/R120d-2E SR
111112113114115116117118119120
1. Turning on the Server
Express5800/R120d-1E User’s Guide
119
Chapter 3 Setup
1.
Turning on the Server
Pressing the POWER switch at the front of the server turns on the server.
Turn on the server by using the following procedure.
Tips
Wait for at least 40 seconds before turning on the server after connecting the
power cord.
Do not power on the server before amber POWER LED is unlit.
1. Turn on the display unit and peripheral devices .
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
2. Remove the front bezel.
3. Press the POWER switch at the front of the server.
The POWER LED is turned on green and after a while, the logo appears on the display unit.
3.5-inch Hard Disk Drive Model
2.5-inch Hard Disk Drive Model
While the logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware.
For details, refer to Chapter 3 (1.1.1 POST sequence).
POWER switch
POWER LED
POWER switch
POWER LED