User's Guide

– [E-mail address]:
Type in the E-mail address for your mail account in the form user@domain.
– [OK]:
Set information is added and this dialog box closes.
– [Cancel]:
This dialog box closes with no set information added.
For the destination settings, make the following settings.
 [Internet Mail Destination Setting] dialog
– [To]:
Type in the E-mail address (To:) in the form user@domain.
Be sure to divide it with , (comma) when you specify plural addresses (e.g. [e-mail],
[e-mail]).
– [Subject]:
Enter a title of the mail.
– [Message Head]:
To send a message, enter information. Message contents of actual mail consist of this message header
and alert information.
– [Enable]:
Mark this check box when you send mail through Remote Access Service (RAS).
Before setting the destination, configure the Remote Access Service. Additionally, set an
entry for the Remote Access Service. If the entry for the Remote Access Service is not set,
this check box cannot be marked.
32