Installation Guide

NEC ESMPRO Manager Ver.5 Installation Guide (Linux)

2.3 Managed component

This section explains conditions for components to be managed by the NEC ESMPRO Manager.

 Hardware

-- Express5800 series and NEC Storage series in which the BMC complying with IPMI Ver.1.5 or

Ver.2.0 is integrated

-- Express5800 series and NEC Storage series in which EXPRESSSCOPE Engine or EXPRESSSCOPE

Engine 2 complying with IPMI Ver.2.0 is integrated

-- Express5800 series and NEC Storage series in which a Remote Management Card [N8115-01CP01]

complying with IPMI Ver.1.5 or Ver.2.0 is integrated

-- Express5800 series and NEC Storage series in which an Advanced Remote Management Card

[N8115-02CP01] complying with IPMI Ver.2.0 is integrated

-- Express5800 series based on vPro including iAMT Ver.6.0 and later

CHECK:

 The monitor function by the SNMP does not support it. NEC ESMPRO Manager will not

be managed as the result of the install. See the "Appendix C. Managed Components

Summary" of the "NEC ESMPRO Manager Ver.5 Setup Guide".

 The required environment varies depending on the connection type with the managed

component. See 2.4"Requirements for Connection between the NEC ESMPRO Manager

Ser

ver and Managed ".

TIPS:

 EXPRESSSCOPE Engine and EXPRESSSCOPE Engine 2 are generically called

EXPRESSSCOPE Engine series.

 Software

-- You cannot use the monitoring function by the SNMP even if you install NEC ESMPRO Agent.

-- If you use NEC ExpressUpdate function that manages versions of modules like firmware and

software, NEC ExpressUpdate Agent is required.

2.4 Requirements for Connection between the NEC ESMPRO

Manager Server and Managed Component

 LAN connection

 TCP/IP network

 LAN port

-- LAN port that BMC uses depends on the type of BMC. Some BMC uses standard LAN port. Other

BMC uses a Management LAN port. See the "Appendix C. Managed Components Summary" of the

"NEC ESMPRO Manager Ver.5 Setup Guide".

-- There are 2 types of managed components that BMC uses standard LAN port: one type is permitted

to use only LAN1 port, and the other type is permitted to use both LAN1 and LAN2 ports. See the

"Appendix C. Managed Components Summary" of the "NEC ESMPRO Manager Ver.5 Setup

Guide".