Installation Guide

[Work Around]
If you have changed each item on “Receive from Agent (TCP/IP)” as user without Administrators privilege, take the
following procedure:
- Logon as a user with Administrators privilege.
- If you have changed each item from Receive valid (green) to Receive invalid (red), restore it to "Receive
valid (green)", and change it to "Receive invalid (red)" again.
- If you have changed each item from Receive invalid (red) to Receive valid (green), restore it to "Receive
invalid (red)", and change it to "Receive valid (green)" again.
♦Maps to be specified at autodiscovery
After you execute Autodiscover on the Operation Window, maps may be displayed as if they were registered infinitely
as shown below:
This problem occurs when a map whose name is the same as its parent map was created at autodiscovery.
In such a case, delete the second mapA(*) (in this example) to resolve the situation.
♦Setting a Windows Firewall
If the Windows Firewall is enabled, communication between NEC ESMPRO Manager and NEC ESMPRO Agent will be
interrupted and the system will not work correctly.
To use NEC ESMPRO Manager with the Windows Firewall enabled, open the following ports:
[Target Ports]
The following table shows the ports for the Windows Firewall to be set on the [Add a Port] dialog box on a machine on
which NEC ESMPRO Manager is installed.
Name (can be changed) Port number Protocol Protocol Environment
Inter-Manager communication 8806 TCP When Inter-Manager communication is
used.
SNMP Trap 162 UDP When Manager Notification (SNMP) is used
(default).
High Reliable Notification 31134 TCP When Manager Notification
(TCP/IP in Band) is used.
Express Notification via Manager 31136 TCP When Express Notification Service is used
via Manager.
For ports used by NEC ESMPRO Manager, see "Appendix Port numbers / Protocols".
67