Installation Guide

- If remote console feature of EXPRESSBUILDER does not support the setting of the function, the tool

always set "disable" for the function when it registers the BMC configuration.

- If NEC ESMPRO Manager does not support the setting of the function, the NEC ESMPRO Manager cannot

set disable for the function nor change IP address when DianaScope Agent support the setting of the

function and the function has been set enable.

2. Advanced Remote Management Card and ft Remote Management Card

If the managed server has been installed Advanced Remote Management Card or ft Remote Management Card,

the BMC may not immediately obtain the IP address after NEC ESMPRO Manager PXE Service configures the

BMC to obtain the IP address by the DHCP. Turn the managed server AC-OFF and then AC-ON because the BMC

try to obtain the IP address whenever the managed server is turned AC-ON.

♦Port that BMC uses

In case that Linux on the managed server uses port 623, NEC ESMPRO Manager cannot communicate with the BMC

that uses standard LAN port.

Perform following settings:

1. Add the following entries in services files (/etc/services) to reserve port 623.

asf-rmcp 623/tcp ASF Remote Management and Control Protocol

asf-rmcp 623/udp ASF Remote Management and Control Protocol

2. Reboot the OS.

♦Initialization of the BMC Configuration Information setting]

When you set [Default value] on the BMC Configuration Information with DianaScope Agent or NEC ESMPRO Agent

Extension, or create New Configuration with [System Management Tool] started from EXPRESSBUILDER DVD-ROM,

each items of the BMC Configuration Information are initialized.

If the managed server integrates EXPRESSSCOPE Engine series, Advanced Remote Management Card or ft Remote

Management Card, following items for BMC Web server are also initialized because they are shared with BMC

Configuration Information:

DHCP Configuration

IP Address

Subnet Mask

Default Gateway

How to set the Web server is following:

 Select [System Management Tool]. on [Tool]. started from EXPRESSBUILDER DVD-ROM, and then select [Web

server of BMC].

 Login to Web server of the BMC, and then select [Configuration] – [Network].