Installation Guide
♦Auto Registration
Even if managed servers that are registered only to the Operation Window are out of the search range for Auto
Registration, they are listed in the Auto Registration list and registered to the NEC ESMPRO Manager as managed
servers.
If any server that is not supported, such as NEC ESMPRO Agent Ver.4.1 or prior, is included in the search range
for Auto Registration, the server is not registered to NEC ESMPRO Manager. However, it is registered to the
Operation Window.
After you register a CPU blade managed via only SNMP to create the chassis information, to register another CPU
blade on the same chassis with the management controller enabled, delete the previously registered CPU blade
managed via SNMP and register it again.
Do not perform other operations or move to another window during Auto Registration or Check Connection.
If a server for which Check Connection is not performed is included in the search range for Auto Registration, be
sure to execute Check Connection for it before Auto Registration.
After auto-discovery is finished from Web browser, the server icon is also put on the Operation Window.
Change the icon location manually if you feel the location is not appropriate.
♦Manually registering server on Operation Window
When manually registering server on Operation Window from menu [View]-[Icon Palette], Web GUI can't show the
corresponding component.
In such a case, do the Auto Registration on Web GUI.
♦Changing properties of the monitored server on Operation Window
When changing properties(below) of the monitored server on Operation Window,
Web GUI can't show the corresponding changes.
- Alias
- IP Address
- SNMP Community Name
- UUID
Changing properties should be done via Web GUI - Connection Setting.
"Alias" on Operation Window and that on Web GUI are saved respectively.
♦Changing Status Polling Interval
The default value for SNMP status polling interval is 1 minute.
To change it, change the value set in [Server Status Polling Interval (min)] on the server icon displayed on the
Operation Window.
♦Recovery from system error
If a system error occurs, follow the instruction displayed on the window.
If no instruction is displayed, restart the browser.
51