Installation Guide

♦Power management

 If you set the value on the managed server which does not support power management, you cannot put back the

value to "unsetting". Set "zero" to each value, it is accepted as "unsetting".

 The electric power value might not necessarily reach even the value of Power Cap value.

The electric power control lowers the power consumption of the system by lowering the frequency of CPU /

Memory.

When CPU / Memory Throttling value reaches 100%, the electric power value doesn't fall any more.

For more detail about the Power Monitoring and Power Control Function, reference the following site.

http://www.58support.nec.co.jp/global/download/index.html

[Others] - [Technology paper]

♦CPU blade auto registration

When "Check Connection" of "CPU blade auto registration" was failed. You can execute "Check Connection" on

"Server Properties" - "Connection Setting".

If a specified IP address is set from a CPU blade to another CPU blade during "CPU blade auto registration" process

(ex. when you replace CPU blade and execute "CPU blade auto registration"), NEC ESMPRO Manager may not be

able to connect the CPU blade because old information remains in the ARP table on the management PC. Wait for a

few minutes and try the "Check Connection".

♦Coexistence of NEC ESMPRO Manager with DianaScope Agent or NEC ESMPRO

Agent Extension on the same server

If the managed server is installed Advanced Remote Management Card or EXPRESSSCOPE Engine series (the BMC

uses exclusive LAN port (management LAN port)), NEC ESMPRO Manager can manage the server itself installed. It

the managed server is installed BMC that uses the standard LAN port, NEC ESMPRO Manager cannot manage the

server itself installed. It is possible only to install NEC ESMPRO Manager and DianaScope Agent or NEC ESMPRO

Agent Extension on the same server. But the communication with BMC on the server is prevented by local loopback

function of OS and the BMC cannot receive any packets from the NEC ESMPRO Manager.

♦EM Card registration

 When you resister the EM Card, you need to set valid on SNMP management and "Management Controller"

management each other.

 If the connection is failed at "Auto Registration" or "Check Connection", it is not recognized as EM Card because

both management is invalid. In this case, set correct connection setting and execute "Check Connection" again.

 If you register the EM Card from Operation Window, the EM Card is registered invalid status on NEC ESMPRO

Manager. So you need to execute "Check Connection" to manage it.