Installation Guide

♦Remote installation of NEC ESMPRO Manager

When installation of the NEC ESMPRO Manager completes, you need to reboot the system.

Careful attention is needed to install the program in the environment where reboot cannot be performed from the Start

menu, such as on Remote Desktop of Windows XP.

The operating system can be restarted by running the following command at Command Prompt:

Ex. ) When you want to restart the system immediately: shutdown -r -t 0

♦Installation for multisession terminal server access

Perform the following operation to install the NEC ESMPRO Manager for multisession Terminal Server access:

 For Windows Server 2003/Windows Server 2003 R2

Use [Add New Programs] from [Add or Remove Programs] in [Control Panel].

 For Windows Server 2008

Use [Install Application on Terminal Server] in [Control Panel].

 For Windows Server 2008 R2

Use [Install Application on Remote Desktop Server] in [Control Panel].

If you do not follow the procedure above, a message indicating the occurrence of the error during the setup

is displayed and the setup stops.

♦ If an older version of NEC ESMPRO Manager has been already installed

 If NEC ESMPRO Manager Ver. 4.1 or later has been already installed, you can update it to this version.

If any version other than the above has been installed, uninstall it before installation.

 Note that if you perform update installation from NEC ESMPRO Manager Ver. 5.0 or prior with the Web Component

installed, the Web Component will be uninstalled at the update installation.

 Note that "BMC Remote Control Tool" for out-of-band management included in the NEC ESMPRO Manager Ver.

4.43 / Ver. 4.51 will be removed and cannot be accessed if you upgrade your NEC ESMPRO Manager to this

version.

♦If DianaScope Manager has been installed

If DianaScope Manager has been installed, you can update it to this version. The information registered to DianaScope

Manager will be inherited.

♦To use the HP OpenView Integration

If you use HP OpenView Integration, install HP OpenView Network Node Manager before installing the NEC ESMPRO

Manager.

The HP OpenView Integration does not support Windows Vista / Windows Server 2008 and later

♦Sample of Script Component

When you changed a sample of the Script Component and saved it as the original file name, change the file name

before performing update installation. If you perform update installation without doing that, the sample will be

overwritten and the changes might be initialized.