Installation Guide
Setting of Teaming for LAN that DianaScope Agent or NEC ESMPRO Agent Extension uses with the OS
(providing redundancy or multiplexing with multiple network adapters) on the managed server installed
BMC that uses a Management LAN port
If the teaming setting is made available for the LAN port that DianaScope Agent uses on the managed server
installed BMC that uses a Management LAN port, see "Appendix B B.2 On the managed server that BMC uses a
Management LAN port" in "NEC ESMPRO Manager Ver.5 Setup Guide".
Change of the hardware of a default gateway or an alert receiver
In case that there is a gateway between a management PC and a managed server, re-configure BMC on the
managed server after the change the hardware of the gateway. In case that there is not gateway between an alert
receiver and a managed server, re-configure BMC on the managed server after the change the hardware of the
alert receiver. The BMC on the managed server can know MAC address of the new hardware by setting the BMC
configuration.
Use of a dialup router or a PPP server
If an alert receiver via modem uses Windows Remote Access Service, select "Allow any authentication including
clear text" about the encryption on the Windows Remote Access Service properties.
Restrictions on use of the standard serial port 2 (COM2)
The standard serial port 2 (COM2) on a managed server cannot be used for connecting another device
in the following cases because the BMC occupies the serial port 2.
- The managed server compatible with SOL and set enable on following BMC Configuration items:
"Remote control (WAN/Direct)"
"Redirection (LAN)"
"Redirection (WAN/Direct)"
- Connection via modem or direct connection has been made.
- Direct connection has been set in the BMC configuration information. (Even if the NEC ESMPRO Manager
and managed server are not connected, the BMC occupies the serial port 2 (COM2).)
See "Appendix C Managed Components Summary" in "NEC ESMPRO Manager Ver.5 Setup Guide" to
confirm whether that your server supports SOL.
18