Installation Guide

 Direct connection (It can be only used to connect with BMC)

- RS-232C cross cable

The serial port for direct connection on ESMPRO server. NEC ESMPRO Manager must be set following on

the operating system.

Bits per speed : It should be set a same value with a value of BMC configuration on a managed server.

The default value of BMC configuration is 19.2Kbps.

Data bits : 8bit

Parity : None

Stop bits : 1bit

Flow control : Hardware (CTS/RTS)

• Do not use an interlink cable.

• Connect the RS-232C cross cable to serial port 2 on the managed server.

• Some models of managed servers do not permit use of any RS-232C cross cable other than the

specified one. See the Maintenance Guide provided with the server.