Installation Guide

If you modify Setting Information of Express Report Service, click [Change Setting…] to show Setting utility of
Express Report Service, which was used for confirmation on installing the service. When the Setting utility is
displayed, modify the setting. When you terminate the setting, [Express Report Setting] window is displayed.
When you access the mail server of provider via dial-up, check the little square of the [enable] in the [Use
remote Access Service]. Next, in [Entries to Use], specify the destination that you access via dial-up, then enter
user name and password.
- Specify the destination used for the access via dial-up on Windows prior to configuration of
[Use remote Access Service].
- Existing User name and password on Windows are not used, even though they are saved. Make
sure to specify user name and password.
15. Click [Test Report].
16. Confirm the sending address of Test Report and click [OK].
17. When the confirmation message is displayed, click [OK] to execute Test report.
When a Test report is executed, Test results mail/facsimi
le is sent to the specified destination.
After confirming the results of Test report, execute Opening report.
18. Click [Opening Report] to confirm the execution.
[Opening Report] button is operative after finishing Test Report.
Express Report Service is launched after Opening report.
19. Click [OK] to close [Express Report(Internet Mail) Setting] window.
20. Click [OK] to close [Express Report Service Setting] window.
21. On [ID Setting] window, click [Schedule...] to specify ˝Retry setting (Interval, Expiration Time) ˝ and
˝Reporting Time Table ˝.
Default value is set as every 5 minutes. Retry for up to 72 hours after is operative at all hours.
This value is recommended. Do not modify the default except for any necessary reason.
22. When the specification is done, click [OK] button to close [Schedule...] window.
19