Installation Guide

8.4 Hardware
♦Display of the [Information of server state/constitution] of NEC ESMPRO Manager
when an odd number of DIMMs are installed
When an odd number of DIMMs are installed, the indication of memory bank is displayed in gray (Not Installed) of
[Information of server state/constitution] of NEC ESMPRO Manager. However, it is not the problem if the locations of
actually installed DIMMs are correct. If any warning/error occurred on DIMM, the indication of memory bank becomes
yellow (Warning) or red (Error) to allow you to detect a memory failure.
8.5 SNMP
♦CPU Load Ratio of SNMP Service (snmp.exe)
While monitoring the server from NEC ESMPRO Manager, the CPU load ratio of SNMP Service on the NEC ESMPRO
Agent side may increase at every monitoring interval (default: 1 minute).
NEC ESMPRO Manager and NEC ESMPRO Agent exchange information through SNMP Service.
If the server status monitoring by NEC ESMPRO Manager is on (default: ON), NEC ESMPRO Manager regularly
issues a request to NEC ESMPRO Agent to get the current status of the server. In response, NEC ESMPRO Agent
checks the status of the server. As a result, the CPU load ratio of SNMP Service increases temporarily.
If you have trouble of terminating a movie player application, turn off the server status monitoring by NEC ESMPRO
Manager or extend the monitoring interval.
♦Hang of SNMP Service
SNMP Service has a module called "SNMP Extended Agent" This module may be registered when you install some
software that uses SNMP Service.
If you start SNMP Service, SNMP Extended Agent is also loaded at the initialization. However, if the initialization is not
completed within a specified period, SNMP Service will hang.
It may take time to complete the initialization due to temporary high load on the system. In this case, wait for the system
load become low enough before restarting SNMP Service.
♦Community Authority
Depending on your OS type or its version, settings for community, SNMP service’s security function, are not made, or
default settings of authority are different.
To enable the remote shutdown and threshold change functions via NEC ESMPRO Manager, make settings of
community and set its authority to "READ CREATE" or "READ WRITE".
27