Maintenance Manual

5. Troubleshooting

Express5800/R120d-1M, R120d-2M Maintenance Guide

Chapter 1 Maintenance

[?] The following devices are indicated as faulty devices in a Windows Server 2008 R2 Server Core

installation environment

• SM Bus Controller

• PCI Simple Communications Controller

• Base System Device

• System Interrupt Controller

• Performance Controller

→ There is no operational problem.

[?] Unable to access the partition which was previously created after reinstalling while several disks are

connected

→ For details, refer to the Microsoft website below:

http://support.microsoft.com/kb/2497048/ja (Japanese only)

[?] When Windows Server 2008 R2 is installed while several disks are connected, the system partition and

the boot partition (100 MB) are sometimes created in another disk

→ For details, refer to the Microsoft website below:

http://support.microsoft.com/kb/2530901/ja (Japanese only)

[?] When Starter Pack is executed on Windows Server 2008 R2, the below message is sometimes displayed

for a moment upon shutdown

→ No problems for system operation.

For details, refer to the Microsoft website below:

http://support.microsoft.com/kb/975777/en-us

[?] Windows Server 2003 R2 DISC 2 was installed after the Windows Server 2003 Service Pack had been

applied

→ Reapply the Service Pack. If you applied the Service Pack even once after installing Windows Server

2003 R2 DISC 2, you need not reapply it.

* If the Service Pack application is unknown when you install Windows Server 2003 R2 DISC 2, NEC

recommends that the Service Pack be reapplied.

[?] The system was installed as Workgroup although it is set to join the domain

 Is the LAN cable properly connected?

→ If the LAN cable is not connected, the system is installed in workgroup setting, not in domain join setting.

After the OS is started, join the domain.

1 program still needs to close:

(Waiting for) Task Host Window