User's Guide

4. Names and Functions of Parts
Chapter 1 General Description
4.3
Rear View
(2)
(1) AC inlet
This socket is used to connect the power cord.
(2) Serial port A (COM A) connector
This connector is used to connect devices that support a
serial interface. Note that it is not possible to directly
connect to a dedicated line.
(3)
LINK/ACT LED (green)
The LED indicates the access status of LAN
(4)
LAN connectors
1000BASE-T/100BASE-TX/10BA
SE-T supported Ethernet
connectors
(5) Speed LED (green/amber)
The LED indicate
s the transfer sp
eed of LAN po
rts
(6) Monitor connector
The connector to connect the mon
itor
(7) DC Power LED (green)
This LED lights green whe
n the power is ON.
(8) USB connectors
These connectors are used to connect devices that
support
the USB interface.
(9) Management LAN port
An Ethernet con
nector w
hich supports
100BASE-TX/10BASE-T.This port cannot be used as a
data transmission port. This port is used for connecting to
EXPRESS SCOPR ENGINE 3.
(10) UID (Unit ID) switch/LED (blue)
The switch to tur
n on and off the UID LEDs provided at the
front and rear of the server. Pressing the switch once turns
on the UID LED and pressing once more turns off the LED.
(11) PCI slot
The slot is used to install the low pr
ofile type PCI board.
The sequential numbers indicate the corresponding slot
numbers.
(3) (4)
(5)
(3) (4) (5)
(6) (8) (7) (9)(4) (5)
(10)
(1)
(11)-1 (11)-2
Express5800/R110d-1E, E110d-1 User’s Guide
34