Installation Guide

8. Windows OS Parameter File
Express5800/R120d-1E, R120d-2E Installation Guide (Windows)
285
Chapter 1 Installing Windows
You can see the default values by clicking [Default
values].
6-1 RAID settings
Use this menu to configure RAID System with the RAID Controller detected automatically.
Note
When using an onboard RAID Controller (LSI Embedded MegaRAID):
This function does not support the creation of RAID10 by using the onboard RAID
Controller. Refer to Chapter 2 (4. RAID System Configuration) in “Maintenance
Guide” when creating RAID10.
Specify the RAID settings using the RAID settings wizard on Parameter Setup Menu.
Important
The number of Physical Devices displayed on the RAID settings wizard is the
upper limit supported by the RAID Controller.
Make sure that the number of actually connected Physical Devices does not
exceed this value.
When creating new logical drives
(1) Click [Settings] in RAID settings.
(2) Use the wizard to set up the logical drives.
Important
If you proceed with wizard, the existing RAID system is destructed and the
contents of hard disk drive will be erased.
When skipping the creation of new logical drives
Click [Skip] in RAID settings.
Return to the parameter setup menu.
Proceed to Windows setup.