Installation Guide

3. Setting Up Windows Server 2008 R2

Express5800/R120d-1E, R120d-2E Installation Guide (Windows)

Chapter 1 Installing Windows

―

 Setup when mass memory is installed

If mass memory is installed in your system, the large size of paging file is required at

installation. Thus, the partition size for storing debug information (dump file) may not be

secured.

If you fail to secure the dump file size, use OS standard installer for setup, and allocate the

required file space to multiple disks by performing the following steps.

1. Set the system partition size to a size sufficient to install the OS and paging file.

2. Specify another disk as destination to store the debug information (required dump file

size) by referring to Chapter 1 (7. Setup for Solving Problems).

If the hard disk drive does not have enough space to write the debug information, set the

partition size to a size sufficient to install the OS and paging file, and then add another

hard disk drive for the dump file.

Note

If the partition size for installing Windows is smaller than the recommended

size, expand the partition size or add another hard disk drive.