User Guide

- 24-
Notice
If you execute “power cycle” under the condition that the “Power
Save” is enabled by BIOS Setup Utility, the powering on after the
powering off will not work. In this case, please try to press power
button of the host system.
Notice
Click “BMC Reset” only if a problem occurs in EXPRESSSCOPE
Engine 3 (BMC). Do not click “BMC Reset” in usual operation. Do not
shutdown the system, reboot the system, or perform any switch
operation after clicking the “BMC Reset” for approximately 3 minutes.
The connections with Web browser and SSH client are disconnected
if you reset the BMC.
Clicking the “BMC Reset” cannot reboot the server.
REMOTE KVM/MEDIA
Menu
I. Video
The features such as Refresh screen, Low bandwidth mode (Normal, 8bpp, 8bpp
B&W, 16bpp display mode are supported depending on the network bandwidth.),
manual video recording, capture screen, full screen are available.
II. Keyboard
The features such as user defined macros, virtual keyboard (software keyboard) for
Japanese/English/French/German are available.
III. Mouse
The features such as changing or synchronizing the mouse cursor, changing the
mouse coordinate mode are available.
IV. Media
Enable or disable the remote device and open the remote media window to connect
or disconnect the remote media.
V. Power
You can do the power on, power off, power cycle, reset, OS Shutdown, NMI dump (If
the memory dump is set on the host system OS.) to the host system.