User Guide

48
5.2.2 Install commands
'load' command at below target enables you to install a module. Refer to the section 5.1.4.1 for more
information about this target.
 /cmps/<Component Name>/map/expup/modules/supportedmods/managedmods/<Module Name>
Specific option of this command is as follow.
Table 5-21 Specific options of '/cmps/<Component Name>/map/expup/modules/supportedmod
s/managedmods/<Module Name>'
Option Description
-source Specifies the update package.
-reboot Enables ExpressUpdate to reboot the system if the installation requires it.
CHECK：
 In the case of the user authority is Operator, "Install Update Packages" of the user level
must be enabled.
Example
`load /cmps/<Component Name>/map/expup/modules/supportedmods/managedmods/<Module Name>`
command enables you to install an module<Module Name> to the specified component<Component Name>.
-> load -source "4.4.1" /cmps/Server01/map/expup/modules/supportedmods/managedmods/"ESMPRO/Ser
verAgent Ver.4.4"
COMMAND COMPLETED
Updating was started. Run the show command to the each module element and you can confirm this
command's progress from ExpUpStatus property. Run the show command to the each module element and
you can confirm this command's result from LatestApplyResult property.
TIP:
 UFiT of the update package that is referred by -source option is shown in the resul
t of `show /cmps/<Component Name>/map/expup/modules/supportedmods/managedmo
ds/<Module Name>/uppkgs` command.