User's Guide

Upgrading Your Server 9-69
Optional RAID Controller (N8103-129/130)
At the factory, the interface cable is connected to the SATA HDD connector on the motherboard.
Refer to the manual coming with optional RAID controller (N8103-129/130) for details.
IMPORTANT: The RAID controller board is extremely sensitive to
static electricity. Make sure to touch the metal frame of the Server to
discharge static electricity from your body before handling the RAID
controller. Do not touch the RAID controller terminals or on-board
parts by a bare hand or place the RAID controller directly on the desk.
For static notes, see page 9-3.
NOTE: Before installing an optional RAID controller, run the SETUP
utility, select [Advanced] → [PCI Configuration], and confirm that
[Enabled] is set for the parameter [PCI Slot xx ROM] (xx: PCI slot
number).
IMPORTANT: When N8103-129/130 is inserted, do not switch to the
hibernation or standby mode.
Installation
See Installing RAID Controller on page 9-59 for the installation of a RAID controller
(N8103-129/130).
Removal
To remove the optional RAID controller (N8103-129/130), perform the above procedure in reverse.