User's Guide

Troubleshooting 8-15
Displayed Error Message Description Recommended Action
C021
System Voltage out of the
range.
A system voltage abnormality
was detected.
C040 SROM data read error SROM data reading error
C041 SROM data checksm bad SROM data checksum error
C060
SMBus device Error
detected.
An error was detected for the
SM Bus.
C061
1st SMBus device Error
detected.
An error was detected for the 1st
SM Bus.
C062
2nd SMBus device Error
detected.
An error was detected for the
2nd SM Bus.
C063
3rd SMBus device Error
detected.
An error was detected for the
3rd SM Bus.
C064
4th SMBus device Error
detected.
An error was detected for the
4th SM Bus.
C065
5th SMBus device Error
detected.
An error was detected for the
5th SM Bus.
C066
6th SMBus device Error
detected.
An error was detected for the
6th SM Bus.
Contact your service
representative.
C101 BMC Memory Test Failed.
C102
BMC Firmware Code Area
CRC check failed.
C103 BMC core hardware failure.
BMC device (chip) error
C104
BMC IBF or OBF check
failed.
Accessing the BMC address
failed.
Turn off the power, and
then restart the server.
If this does not resolve
the problem, contact
your service
representative.
C105 BMC SEL area full.
There is not enough capacity to
write the system event log.
Start up the BIOS setup
utility, select [Clear All
Error Logs] under
[Event Log
Configuration] on the
[Server] menu, and
then press the Enter
key to delete the logs.