User's Guide

1. Installing Internal Optional Devices

Express5800/R110g-1E User’s Guide

Chapter 2 Preparations

(b) Using an optional RAID controller

Jumper on motherboard (SWRAID)

Change the jumper setting to 1-2 (Disabled).

Change the jumper setting of the backplane for the hard disk drive.

Backplane for 3.5-inch hard disk drive (J3)

Note

When installing an optional RAID Controller, start the BIOS Setup utility, select PCI

Configuration from the Advanced menu, and then make sure that the parameter

of PCI Slot xx ROM (xx is PCI slot number) is set to Enabled.

Important

Do not change the mode to hibernate when building a RAID System.

Motherboard

3 2 1

Enabled

WRAID

Disabled

(Factory seting)

Backplane for 2.5-inch hard disk drive (J3)

Optional RAID Controller

Optional RAID controller

Onboard SATA

controller

Onboard SATA

controller