User's Guide

2. System BIOS Setup
Express5800/R110g-1E User’s Guide
127
Chapter 3 Setup
2.4
Cases that Require Setting Changes
Specify parameters according to the following table when your system matches "Description". The list of
SETUP parameters and factory settings are described in Chapter 2 (1. System BIOS) in "Maintenance
Guide".
Category Description To be changed Remark
Basic Change date and time Main  System Date
Main  System Time
Configurable on OS
On/Off NumLock on power ON Boot  Bootup Numlock State
On/Off the function to display
NEC logo during POST
Boot  Quite Boot  Disabled By pressing <Esc> key, prevent
the display of the logo.
Memory Configure the memory after the
DIMM is added or exchanged.
Advanced  Memory Configuration 
Memory Retest  Yes
After rebooting, the Memory
Retest setting changes to No
automatically.
Optional
board
Install RAID Controller board Advanced  PCI Configuration  PCI
Device Controller and Option ROM
Settings  PCI Slot n Option ROM 
Enabled
n is PCI slot number of the RAID
Controller
When an optional board is
installed, set to [Disabled] for
Option ROM for all PCI devices
except for the boot device.
Advanced  PCI Configuration  PCI
Device Controller and Option ROM
Settings  PCI Slot n Option ROM 
Enabled
"n": Slot number in the PCI
device (except for the boot
device)
Advanced  PCI Configuration  PCI
Device Controller and Option ROM
Settings  LAN1 Option ROM Scan 
Disabled
Option ROM on LAN1 must be
disabled.
Boot Change the boot order of
devices
Boot  Boot Option Priorities 
Change the boot priority
Use remote power on feature
(from modem)
Advanced  Advanced Chipset
Configuration  Wake On Ring 
Enabled
Use remote power on feature
(from RTC alarm)
Advanced  Advanced Chipset
Configuration  Wake On RTC Alarm
 Enabled
Control from HW console
terminal
Advanced  Serial Port Configuration
 Change respective setting.
Security Set a password to restrict
operation of SETUP.
Security  Administrator Password 
Security  User password
After a password is set, the
entry of password is displayed
when SETUP is launched.
Set a password to restrict
booting.
Security  Password on Boot 
Enabled
You can select this parameter
after you set a password.