User's Guide

1. Turning on the Server
Express5800/R110g-1E User’s Guide
121
Chapter 3 Setup
1.
Turning on the Server
Turn on the server by using the following procedure.
Tips
After connecting the power cord or turning off the server, wait for at least 30
seconds before pressing the POWER switch when the server is OFF.
If the optional RAID Controller N8103-168 is installed, wait for at least 90 seconds
before turning on the server after turning off the power.
Turn on the peripheral devices such as display unit. 1.
Note
If the power cord is connected to power control system such as an Uninterruptible
Power Supply (UPS), make sure that the power control system is turned on.
Remove the front bezel. 2.
If POWER LED lights amber, wait until POWER LED is unlit. 3.
Press POWER Switch at the front of the server. 4.
POWER LED is turned on green and after a while, NEC logo appears on the display.
Important
Do not turn off the server until NEC logo and some characters are displayed.
While NEC logo is being displayed, the self-diagnostic program (POST) runs and diagnoses the hardware.
For details, see Chapter 3 (1.1.1 POST sequence).
POWER LED
POWER Switch