Reference Guide

73
2.4 Chassis Management Commands
2.4.1 getBladeEnclosureList
Syntax:
dscli getBladeEnclosureList
Description:
Displays the list of the blade enclosure in which the managed component or the EM card registered on NEC
ESMPRO Manager is installed.
Output:
Displays the list of the blade enclosure with the component or the EM card registered on NEC ESMPRO
Manager.
2.4.2 getChassisSlotState
Syntax:
dscli getChassisSlotState ChassisName
Description:
Displays the state of blade slots when the specified chassis is a blade enclosure. The list of the EM card and
the switch module are displayed if the EM card and the switch module are installed in chassis.
Options:
ChassisName
Specify the chassis name.
Output:
Following information is shown for each slot.
Contents Explanation
slot number Displays the slot number.
Displays two slot numbers when the installed blade has double wide or full height.
component name Displays the component name when the component is
installed in the slot and it is registered on NEC ESMPRO
Manager. For double wide blade, displays “(Double-wide)”
following the component name. For full height blade,
displays “(Full-height)” following the component name.
Installed Displays “Installed” when the switch module is installed in
the slot.
Not registered Displays “Not registered” when the component is installed
in the slot and it is not registered on NEC ESMPRO
Manager.
Not installed Display “Not Installed” when nothing is installed in the slot.
slot state
(blank) Displays nothing if “Installed” and “Not Registered” cannot
be distinguished.