Installation Guide

36
Agent or NEC
managed server is installed Advanced Remote Management Card or EXPRESSSCOPE Engine
ager can manage the
d BM N port, NEC
MPRO Agent Extension (formerly DianaScope Agent)
ation with BMC on the server is prevented by local loopback function
ets from NEC ESMPRO Manager.
 When you resister EM Card, you need to set valid on SNMP management and "Management Controller"
her.
gnized as EM Card
setting and execute "Check
hen uted from NEC ESMPRO
Mana
er following BMC.
r equivalent BMC
If you exit and restart the monitoring window of NEC ESMPRO Manag
er with AlertViewer started, the
displayed AlertViewer window is rewritten and the window may not be properly displayed.
In such a case, exit the monitoring window and AlertViewer once, and then restart them.
♦ Usage of DHCP
NEC ESMPRO Manager and managed servers communicate by the IP address on OS.
Therefore, do not use DHCP on NEC ESMPRO Manager's OS and managed server's OS.
♦ Coexistence of NEC ESMPRO Manager with DianaScope
ESMPRO Agent Extension on the same server
If the
series (BMC uses exclusive LAN port (management LAN port)), NEC ESMPRO Man
server itself installed. If the managed server is installe C that uses the standard LA
ESMPRO Manager on the managed server cannot manage itself.
You can install NEC ESMPRO Manager and NEC ES
on the same server, but the communic
of OS and BMC cannot receive any pack
♦ EM Card registration
mana
gement each ot
 If the connection is failed at "Auto Registration" or "Check Connection", it is not reco
because both management is invalid. In this case, set correct connection
Connection" again.
♦ Remote Control
W all the following conditions are satisfied, remote control cannot be exec
ger.
 The managed server has eith
- BMC uses standard LAN port
- Advanced Remote Management Card o
 The managed server has been power off.
♦ Display of the monitoring window