Installation Guide

3. Setting Up Windows Server 2012 R2

Express5800/T110g-S, R110g-1E, T110g-E Installation Guide (Windows)

Chapter 1 Installing Windows

3.5

Setting Up Device Drivers

Install and set up device drivers provided for the standard configuration.

For details regarding the installation and setup of a driver for an optional device, refer to the manual supplied

with the optional device.

Installing the LAN drivers

3.5.1

(1) LAN drivers

If EXPRESSBUILDER is used for setup, the LAN driver will automatically be installed.

If the Windows standard installer is used for setup, install Starter Pack to install the LAN driver.

Important

 Teaming of network adapters by using BACS is not supported.

 WOL is supported by the standard network adapters only.

Note

 To change the LAN or BACS driver settings, log on to the system from a local

console using an administrator’s account. Remotely changing the settings by

using the operating system’s remote desktop feature is not supported.

 Be sure to select the Internet Protocol (TCP/IP) check box when specifying an

IP address.

(2) Optional LAN board

This server supports the following optional LAN boards.

Optional LAN boards: N8104-128/132/133/138

The drivers for LAN boards are automatically installed using the OS plug-and-play function.

Note

Using an optional LAN board, perform procedure "3.5.2 Setting up LAN drivers" for

each optional LAN board.

(3) Network adapter name

After installing the LAN drivers, the following network adapter names will be displayed by the Device Manager.

Network adapters for the standard configuration

Broadcom NetXtreme Gigabit Ethernet #xx*

If connecting with an optional LAN board:

[N8104-128] Broadcom BCM57711 NetXtreme II 10 GigE (NDIS VBD Client) #xx*

[N8104-132/133/138] Broadcom NetXtreme Gigabit Ethernet #xx*

* If there are adapters with the same name, a different identification number will be assigned to xx.

Tips

The ID for N8104-128 might be a number of two or more digits. This is due to the

LAN driver specifications and not an error. This number cannot be changed.