Installation Guide

4. Setting Up Windows Server 2012
Express5800/T110g-S, R110g-1E, T110g-E Installation Guide (Windows)
143
Chapter 1 Installing Windows
Setting up LAN drivers
4.5.2
(1) Setting link speed
The transfer rate and duplex mode of the network adapter must be the same as those of the switching hub.
Follow the procedure below to specify the transfer rate and duplex mode.
Tips
Using N8104-128 default speed duplex (10Gb Full), there is no problem using
switch with "Autonegotiation" speed duplex.
1. Open the Device Manager.
2. Expand Network Adapters, and then double-click the name of the network adapter you want to set.
The properties of the network adapter will be displayed.
3. On the Advanced tab, set the Speed & Duplex values to the same as those of the switching hub.
4. Click OK in the Network Adapter Properties dialog box.
5. Restart the system.
The link speed setting is now complete.
(2) Using N8104-132/133/138
Using N8104-132/133/138 with the server, follow the procedure below to set it.
1. Insert EXPRESSBUILDER DVD into the optical disk drive.
If Autorun Menu appears, close the menu.
Tips
EXPRESSBUILDER DVD is unnecessary if Starter Pack was installed from
Internal Flash Memory. Proceed to the next step.
2. Double-click pgdyavd_disable.vbs in the following folder.
When using EXPRESSBUILDER DVD:
EXPRESSBUILDER DVD:\006\win\winnt\ws2012\lan\bcom\ws2012x64\lan
If Starter Pack was installed from Internal Flash Memory:
System drive:\StartPKG\ws2012\lan\bcom\ws2012x64\lan
3. When the following message appears, click OK.
Tips
The message “Action:Non” indicates that the LAN driver is already set.
4. Eject EXPRESSBUILDER DVD from the optical disk drive, and then restart the system.
Setup is now completed.
Configuration Completed
[Option:PopUp RLV Disabled(Action:Done)]
Reboot the system