User Guide

- 11-
Command Line Interface:
SSH
Select [Enabled] to use the Command Line Interface using SSH. If not, select
[Disabled]. (Default setting is [Enabled](*).)
SSH Port Number
Specify the BMC’s SSH port number. (Default setting is 22.)
BMC Initialization
The BMC Configuration will be cleared. Please use this function when you forgot
your user name and password, etc. for remote management via a Web browser and
command line interface. This function will be executed when you select "YES" on
confirmation menu which appears after pressing the “Enter” key. This menu invokes
the BMC configuration clear operation after selecting the "YES".
Notice
•
These BMC Management LAN-related settings of BMC are not
changed to default settings by executing the "Load Setup Default"
of BIOS Setup Utility. (Execute the "BMC Initialization" to set
default settings to the BMC Management LAN settings.)
• When "BMC Initialization" is executed, BMC is reset. It will take
about two minutes by the time initialization is completed after it
executes it. During the initialization, Do not shutdown the system,
reboot the system, or perform any switch operation after pressing
the BMC reset button,
The BMC Initialization also deletes the settings for NEC ESMPRO
Manager(a software application bundled for remote management). Be
sure to perform a backup for the NEC ESMPRO Manager settings before
you change the BMC settings.
* In some systems, the default settings are different for DCHP, HTTP, HTTPS, and/or SSH.