User Guide

- 10-
Connection Type
Select appropriate setting for link speed and duplex mode which you need.
Following settings are available. (Default setting is [Auto Negotiation].)
- Auto Negotiation
- 100Mbps Full Duplex
- 100Mbps Half Duplex
- 10Mbps Full Duplex
- 10Mbps Half Duplex
Notice
Select [Auto Negotiation] if the link speed and duplex mode
(Connection Type) of the switch (such as HUB) connected to the
Management LAN is [Auto Negotiation]. If you would like to use the
other setting (not “Auto Negotiation”), at first, select the other setting
of the switch (such as HUB) connected to the management LAN, and
then select the same setting as the switch to the Connection Type of
the management LAN.
IP Address
If DHCP is not used to automatically obtain an IP address, enter the BMC’s IP
address.
If DHCP has been used, an automatically obtained IP address will appear.
(Default setting is 192.168.1.1.)
Subnet Mask
If DHCP is not used to automatically obtain a subnet mask IP address, enter the
subnet mask of your management LAN.
If DHCP has been used, an automatically obtained subnet mask IP address will
appear. (Default setting is 255.255.255.0.)
Default Gateway
If DHCP is not used to automatically obtain a default gateway IP address, enter the
default gateway of your management LAN.
If DHCP has been used, an automatically obtained default gateway will appear.
(Default setting is 0.0.0.0.)
DHCP
If you want to obtain an IP address, choose [Enabled].
If you want to manually configure an IP address, choose [Disabled].
(Default setting is [Disabled](*).)
Web Interface:
HTTP Interface
Select [Enabled] to use the Web Server function using the HTTP. If not, select
[Disabled]. (Default setting is [Enabled](*). )
HTTP Port Number
Specify the HTTP port number. (Default setting is 80.)
HTTPS Interface
Select [Enabled] to use the Web Server function using the HTTPS(SSL). If not,
select [Disabled]. (Default setting is [Enabled](*).)
HTTPS Port Number
Specify the HTTPS(SSL)port number. (Default setting is 443.)