Reference Guide

76
2.4.6 setBladeAutoSetting
Syntax:
dscli setBladeAutoSetting ChassisName SlotNumber PropertyName Value
Description:
This command is effective only to the chassis in which EM card can be installed.
If NEC ESMPRO Manger detects new CPU blade installed on the chassis, NEC ESMPRO Manager
configures BMC on the CPU blade (managed component) through the EM card to control the managed
component remotely.
Set information to perform the configuration of BMC on CPU blade and the component registration
automatically.
Options:
ChassisName
Specify the chassis name.
SlotNumber
Specify the slot number of CPU blade. When a common value to all slots is set, “all” is specified.
PropertyName
Specify the name of the chassis property. See the list below.
Value
Specify a new value to be set. See the list below.
PropertyName Contents Value
AUTH_KEY Specify the authentication key that is
configured on BMC.
Up to 16 characters
RECONFIGURE_ BMC “Enabled" means that NEC ESMPEO
Manager executes BMC configuration not
only new installed CPU blade but also all
CPU blade. “Disabled” means that NEC
ESMPRO Manager executes BMC
configuration only if BMC on new installed
CPU blade has not been configured.
0: Disabled
1: Enabled
REWRITE_IP_ADDRE
SS
IP address of the BMC on the CPU blade
may be obtained by DHCP even through the
BMC configuration has not been executed.
If this option is set “Enable”, NEC ESMPRO
Manager always update the IP address
when BMC configuration is executed.
0: Disabled
1: Enabled
DHCP BMC automatically acquires IP address from
DHCP.
0: Disabled
1: Enabled
IP_ADDRESS Specify IP address set to CPU blade. When
you specify “all” for “SlotNumber” option, IP
address consecutive from specified IP
address is sequentially set from the first slot.
IP Address form
SUBNET_MASK Specify the subnet mask. IP Address form
DEFAULT_GATEWAY Specify the default gateway. IP Address form
ALERT_RECEIVER_IP
_ADDRESS
Specify the alert receiver(1)/IP address of
PC for management.
IP Address form