Installation Guide

3. Setting Up Windows Server 2012
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
76
Chapter 1 Installing Windows
2. Open Command Prompt, and execute install.bat in the following folder.
When using EXPRESSBUILDER DVD:
EXPRESSBUILDER DVD:\001\win\winnt\ws2012\lan\intel
If Starter Pack was installed from Internal Flash Memory:
System Drive:\StartPKG\ws2012\lan\intel
3. When Command Prompt returns to a wait status, remove the EXPRESSBUILDER DVD from the optical
disk drive, and then restart the system.
Setup is now completed.
Note
Using an optional LAN board, perform procedure "3.5.2 Setting up LAN drivers" for
each optional LAN board.
(3) Network adapter name
After installing the LAN drivers, the following network adapter names will be displayed by the Device Manager.
Network adapters for the standard configuration
Broadcom NetXtreme Gigabit Ethernet #xx*
If connecting with an optional LAN board:
[N8104-128] Broadcom BCM57711 NetXtreme II 10 GigE (NDIS VBD Client) #xx*
[N8104-132/138] Broadcom NetXtreme Gigabit Ethernet #xx*
[N8104-145] Intel(R) Ethernet Server Adapter I340-T2 #xx*
* If there are adapters with the same name, a different identification number will be assigned to xx.
Tips
The ID for N8104-128 might be a number of two or more digits. This is due to the
LAN driver specifications and not an error. This number cannot be changed.
3.5.2
Setting up LAN drivers
(1) Setting link speed
The transfer rate and duplex mode of the network adapter must be the same as those of the switching hub.
Follow the procedure below to specify the transfer rate and duplex mode.
1. Open the Device Manager.
2. Expand Network Adapters, and then double-click the name of the network adapter you want to set.
The properties of the network adapter will be displayed.
3. On the Advanced tab, set the Speed & Duplex values to the same as those of the switching hub.
4. Click OK in the Network Adapter Properties dialog box.
5. Restart the system.
The link speed setting is now complete.