Installation Guide

3. Setting Up Windows Server 2012

Express5800/T110f-S, R110f-1E Installation Guide (Windows)

Chapter 1 Installing Windows

21. When the following message appears, select the installation type.

Select Custom: Install Windows only (advanced) in this case.

22. “Where do you want to install Windows?” window appears.

Note

If the driver was loaded in steps 17 and 18, or if a RAID Controller is not used, go to

step 26.

Click Load Driver.

If the following message appears, replace the OS installation media and EXPRESSBUILDER DVD in the

optical disk drive, and then click Browse. Next, go to step 23.

Load Driver

To install the driver needed to access your hard drive, insert

the installation media containing the driver files, and then click

OK.

Note: The installation media can be a floppy disk, CD, DVD, or

USB flash drive.

[Browse] [OK] [Cancel]

Tips

• If using Internal Flash Memory, you do not need to remove the OS installation

media.

• At this time, the message “The Installation media can be a floppy disk, CD, DVD,

or USB flash drive.” Appears on the screen, use the supplied

EXPRESSBUILDER DVD or Internal Flash Memory.

23. Specify the following locations, and then click OK.

(When using EXPRESSBUILDER, select the optical disk drive. When using Internal Flash Memory, select

the volume of INTER-FLASH.)

If using the onboard RAID Controller (LSI Embedded MegaRAID) and a USB-DVD drive:

\001\win\winnt\oemfd\ws2012\megasr1

Tips

The driver does not have to be loaded at this time if it was loaded in steps 17 and

18.