Installation Guide

6. Setup for Solving Problems
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
256
Chapter 1 Installing Windows
12. Click OK.
The message to restart the system appears depending on the modifications made.
In this case, restart the system.
Specification of the memory dump settings is now complete.
6.1.3
For Windows Server 2008 (32-bit)
Follow the procedure below to specify the memory dump settings.
1. On the Start menu, click Control Panel, and then click System.
The System dialog box appears.
2. Click Advanced system settings.
The System Properties dialog box appears.
3. On the Advanced tab, click Settings in Startup and Recovery.
4. Type a file name to store the debug information in the Dump file text box.
For example: To store the debug information in D drive under the file name MEMORY.DMP:
D:\MEMORY.DMP
Note the following when specifying a dump file.
• For the Write debugging information drop-down list, we recommend specifying Complete
memory dump. If the mounted memory size is greater than 2 GB, Complete memory dump
cannot be specified because it is not displayed on the drop-down list. In this case, specify
Kernel memory dump instead.
• Specify a drive that has a free space of at least "the memory capacity mounted on the
server + 300 MB" (or 2048 MB + 300 MB if the memory size exceeds 2 GB).
• The size of the debug information (memory dump) changes when DIMM is added. Make
sure that the free space of the drive to store the debug information is sufficient. If the
mounted memory exceeds 2GB, specify Kernel memory dump.
5. In Performance, click Settings.
The Performance Options dialog box appears.
6. On the Performance Options dialog box, click the Advanced tab.
7. In Virtual memory, click Change.
8. Clear the Automatically manage paging file size for all drives check box, and then click Custom
size.
9. In Paging file size for each drive, specify as follows:
For the Initial size text box, type a value equal to or greater than the Recommended value shown in
Total paging file size for all drives.
For the Maximum size text box, type a value equal to or greater than the value specified in Initial size.
After specifying the above values, click Set.