Installation Guide

5. Setting Up Windows Server 2008 (32-bit)
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
244
Chapter 1 Installing Windows
3. Obtain an installation ID for Windows activation.
At the command prompt, enter the following, and then press <Enter> key.
slmgr -dti
4. Reference %systemroot%\system32\slui\phone.inf for the telephone number of the license
authentication customer service.
5. Call the above number, inform the representative of the installation ID which you obtained in step 3, and
receive a confirmation ID.
6. Type the confirmation ID you received in step 5.
At the command prompt, enter the following, and then press <Enter> key. CID is the confirmation ID that
you received from customer service.
slmgr -atp CID
Windows activation is now complete.
5.8
Applying Service Pack
When applying Service Pack 2, refer to the following Microsoft website:
http://support.microsoft.com/kb/948465/en-us
5.9
Installing the Applications
EXPRESSBUILDER contains applications including NEC ESMPRO Agent and NEC ESMPRO Manager. Some
applications stored in EXPRESSBUILDER can be installed collectively by performing the procedures described
below. When installing these applications individually, see Chapter 2 (Installing Bundled Software).
This feature is only available for Full installations.
1. Log on to the system with the built-in administrator, which has administrative privileges.
2. Insert the EXPRESSBUILDER DVD into the optical disk drive.