Installation Guide

5. Setting Up Windows Server 2008 (32-bit)
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
238
Chapter 1 Installing Windows
10. On the Settings tab, click Test Switch. Click Run test on the Test Switch screen.
Test completes when a message indicating successful operation is displayed.
Important
Even if the test result is correct, the message below may appear.
Check the setting of the switching hub (L2) port. If no problem is found,
ignore the message.
"The switch is configured with aggregated ports, but the team type does
not support port aggregation. The switch is configured with VLAN tagging,
but the team has no VLANs."
"Reconfigure the switch for link aggregation, or disable VLAN tagging on
the switch."
Note
Before running the test, confirm whether the adapter status is "Active" or "Standby"
on the Settings tab. If any error is displayed, read the message and change the
setting of the switching hub.
11. Confirm the result in Test results.
12. Restart the system.
(3) Procedure for deleting team
1. Open the Device Manager.
2. Click Network adapters, and then open TEAM: "Team name" properties.
3. Click the Settings tab.
4. Click the Remove Team button.
5. Click Yes to the message.
6. Confirm that the TEAM: "Team name" adapter does not exist in the Network adapters tree, and
then restart the system.