Installation Guide

5. Setting Up Windows Server 2008 (32-bit)
Express5800/T110f-S, R110f-1E Installation Guide (Windows)
237
Chapter 1 Installing Windows
Note
• Static Link Aggregation (SLA) requires switch support.
• The adapters specified as a group of Adaptive Load Balancing (ALB) can
only be connected to the switching hub.
• Confirm that the setting of the switching hub (L2) port matches the setting of
the server network adapter teaming mode.
• For how to delete an adapter team, refer to Chapter 1 (5.5.4 Setting up team
(PROSet) - (3) Procedure for deleting team).
Check the following points when deleting an adapter team.
− When replacing the motherboard or optional LAN boards after an adapter
team is configured, delete the adapter team first.
− If a team exists, delete the team first. If the team is bound to a Hyper-V virtual
adapter, unbind the Hyper-V adapter before deleting the team.
(2) Setting up team
Important
Possible combinations of network adapters that compose the team are as
follows.
When the number of adapters that composes the team is up to four:
- Between N8104-145 adapters
1. Open the Device Manager.
2. Open Network adapters, and then the Intel(R) xxx properties.
3. On the Teaming tab, select the Team this adapter with other adapters check box.
Click New Team.
4. Type the name of the team in Specify a name for the team, and then click Next.
5. Include the adapter to the team, and then click Next.
6. Select a team mode, and then click Next.
Tips
The following team types are supported.
− Adapter Fault Tolerance
− Adaptive Load Balancing
− Static Link Aggregation
− Switch Fault Tolerance
7. Click Finish.
8. Click TEAM: "Team name" from the Device Manager, and then Network adapters to modify the
team.
On the Settings tab, click the Modify Team button.
9. Refer to the following procedure to set the team member adapter priority status.
Note
Adapter priority config can be confirmed by the following procedure:
1. Click TEAM: "Team name” from Device manager, and then open Network
adapters.
2. On the Settings tab, confirm the adapters in team list.